The weather has been very fine and hot. The real working enthusiasm has not been there.
I have dispute that been doing some work.
The splash aprons is bended in a roll so that I can get the right curve.Firts thing to do is make an test plate that has the right angels. It seems to fit good and I take the real length 2meters.
Then begins the real job. After the 90 degrees curve I tried to fit the plates in the right place .But they did not fit at all in the inside of the front fenders. Back to my press tool and try too make the bend better!!! Only a rebuilding of the tool and some hours too measure and more pressing. Now the radius is right .Then after some measuring I could bend 90 degrees in the bottom .Now the fitting too the rear of the front fender begins. I have done most of the fitting on the right front fender. Even three bolts and the riveted bolt for the wheel trunk!
More parts has been bought the head gasket to the engine. Repair kit and new top to the fuel pump. An speedometer that seems to be right.
Just when I am writing this my contact calls and says that my bearings is very hard to find and it costs much.They where for the gearbox and the rear axel. Anyone that can help?

assec

fenderri

gearbox

sideplate1

testplate

trunk